Register a Pick using Single-Scan Bar Codes
If bar codes have been set up, you are able to scan a bar code, which inputs the information in to Floor.
If you are using single-scan, you are not able to split picks. When scanning, the scanned data must match the pick information.
Prerequisites
One of the following setups has been performed:
A warehouse shipment was created and, on the JustFood Floor Setup page, the Whse. Shipment Pick Creation check box was selected.
A warehouse pick was created where the Do Not Fill Qty. to Handle check box was selected.
To register a pick using single-scan bar codes
From the Main Menu, choose Shipping.
Depending on whether a warehouse pick was created, perform one of the following procedures:
If a warehouse pick was not created and, on the JustFood Floor Setup page, the Whse. Shipment Pick Creation check box was selected, perform the following steps:
Choose Whse. Shipping.
Enter the search parameters, and then choose Search.
Select the warehouse shipment that you want to open.
Choose Open.
If items are available to pick, a warehouse pick is automatically created.
The Warehouse Shipment Lines page opens.
Select the line that you want to pick.
The Guided Pick Entry page opens.
If a warehouse pick was created, perform the following steps:
Choose Whse. Pick.
The Picks page opens.
To view the list of warehouse picks, enter the search parameters, and then choose Search.
Select the warehouse pick, and then choose Open.
The Guided Pick Entry page opens.
Enter or scan the Take bin, and then press Enter.
Scan a label, which inputs the data from the bar code.
When all of the lines have been picked, to register the entire pick, on the Pick Entry page, choose Post.